drill edm-Control of the discharge
Improved body ridrill edmgidity in order to increase accuracy， the feed screw and the guide bar using a large-scale high-rigid materials， the shipping weight of 6000kg the workpiece， the deflection control of the bench above in less than 10μm。 Control of the discharge， can suppress the deformation due to the deflection of wire electrical discharge GS Cut "。 Through the use of working fluids (water) from the top and bottom part of the nozzle to impose a high pressure into the processing part of the "HEAT" technology to achieve high-speed processing。 Nozzle to leave the state of the workpiece surface can be as much as possible the processing of liquid poured into the processing part， not only in the nozzle close to the workpiece。 Working fluid temperature in 0。1 ° C for management， with the temperature control device within the body to maintain body temperature at a certain level， which can suppress the thermal deformation。
Installed to take the workpiece from the body front and side three directions， so you can easily prepare job before the process。 Processing tank wall is lower than the workpiece， and even interrupt processing， the lower end of maintenance operations， without having to remove the workpiece。 Come into contact with are being sent by wire electrical discharge， the supply current of the power supply board can also be easily consume replacement。 Envisaged for large parts may need replacement in the processing of the way the use of consumables。
文章定位：
